The backhoe's mainframe fits into rear mounting brackets installed on the tractor. This provides the following important features:

Vertical or side-to-side movement is virtually eliminated, providing more stability. The design of the mainframe also positions the entire backhoe close to the tractor. Operators are also able to benefit from the total weight transfer between the backhoe stabilizers and loader bucket.
The tractor chassis is protected because the mainframe integrates the tractor and backhoe combination together as one.
Once the mounting frame is installed, attaching and detaching is quick and easy.

Remove the top center-link from the tractor
Install the backhoe crossbar into the 3-point hitch draft arms using retainer pins provided. Be sure the draft arms are level side to side.
Lower the 3-point hitch to the lowest position and slowly back the tractor into the backhoe, engaging the lift rods into the slots on the mainframe.
Fully raise the 3-point hitch.
Turn off the tractor and engage the parking brake.
Secure the backhoe to the tractor using the locking pin on the backhoe.
Lower the 3-point hitch to the lowest position.
Remove the power beyond hose loop and connect the power beyond hoses on the backhoe.

NOTE: Review the operator’s manual for detailed procedures. Detailed instructions are also located on the rear of the control panel.

Select a firm, level site to remove the backhoe and engage the tractor park brake.
Lock boom swing using the swing locking pin.
Lower stabilizers until horizontal.
Lower boom and install the boom locking pin in the park position.
Position the dipper so that it is perpendicular to the ground and position bucket with the teeth parallel with the ground.
Turn off the tractor.
Disconnect the power beyond from the backhoe and install the power beyond hose loop.
Turn on the tractor and raise the 3-point hitch to the highest position and remove the backhoe locking pins.
Turn on the tractor and lower the 3-point hitch. Be sure the crossbar is released from the slots in the mainframe.
Release the park brake and slowly drive the tractor forward until the crossbar clears the backhoe.
Turn off tractor and engage the parking brake. Remove the crossbar from the lower draft links and install the 3-point hitch center-link.

NOTE: Review the operator’s manual for detailed procedures. Detailed instructions are also located on the rear of the control panel.

270B Backhoe