700M Loader on 7R 210 Tractor

John Deere loaders are quickly attached and detached from the tractor without the need for tools. With easy-to-use mast pins, parking stands, and single-point hydraulic connection, the loader can be removed and reinstalled in minutes. To work in applications outside of loader use, John Deere loaders provide an efficient solution to park the loader.

Loader mast pin

Parking stand

Single-point hydraulic connection

Removal and parking of the loader can be done with the following instructions:

Apply slight down pressure to the loader boom with the bucket dumped at approximately a 30-degree angle.
With the tractor in park, install the parking stands and place the mast pins in the open position.
Utilizing the boom circuit with the tractor in neutral, rotate the mast forward until the mast has rotated past the pin location on the mounting frame by extending the lift cylinder. Using the bucket circuit, rollback the bucket until the mast is removed from the pocket and will clear the tires.
With the tractor in park, shut the engine off and relieve the hydraulic pressure as indicated for the tractor. Relieve pressure on the single-point hydraulic connection, then disconnect or open the single-point hydraulic connector.
Store the loader half of the single-point connector on the side of the loader boom. The tractor is now ready to back away from the loader.